This Standing Desk is made from 2x12s wood board and plumbers pipe. The height of the desk can be adjusted by switching out different sections of pipe. All of the materials for this standing desk can be purchased at Home Depot.
- 1 – 2″x12″x12′ board
- 6 – 10″ mending plates
- 3/4″ black iron pipes
- 4 @ 18″
- 6 @ 12″
- 4 @ 10″
- 8 @ 4″
- **These measurements are for a 42″ high desk**
- 3/4″ black iron couplings
- 8 – flanges
- 8 – t’s
- 4 – 90° elbows
- 4 – end caps
- 1/4″ black drywall screws
- Danish oil (or stain/protective coat of choice)
- circular saw
- orbital sander
- 18 Volt cordless drill
Step 1: Measure & Cut the Boards
Cut the boards to the finish length of 5’6″, using a speed square to make sure to get a perfect right angle cut.
Step 2: Sand the Boards
Sand the boards down, first using a coarser grit like 100, then finishing at 22o using the orbital sander. We made sure to take special care to round all the edges and corners to get a smooth look.
Step 3: Wipe and Stain the Boards
Wipe all the dust from the boards before using a rag to apply a coat of natural Danish oil. The natural Danish oil gives a coat of protection for the boards while keeping the integrity and clarity of the natural wood color.
Step 4: Attach the Boards Together
Using the 10″ mending plates, attach the 2 2″x12″ boards together. We centered the plates 4″ in from the ends of the boards, then roughly 12″ apart leaving about 6″ of space between the middle two. To ensure that the boards stay together, clamp one board to the worktable and ask for help to pull the second board into the first as you screw in the plates.
Step 5: Assemble the Legs
Assemble the legs using all the pipes and connectors. Putting them together is easy and fun, but make sure that the end result is straight and screwed together tightly.
Step 6: Attach Legs to Boards
Place the legs on the inside of the outermost plate, or about 6″ in from the ends and 3″ in from the sides. It can be a bit difficult to maneuver the drill while it’s so close to the pipes, but be sure to drill the screws straight into the wood.
Step 7: Adjust Legs as Needed
If the floor of your space is uneven, you can adjust the end caps to level the tables.
There are many different options for the height of your desk. We listed the three that we found most useful for our needs. The exact height of the desk will fluctuate depending on how tightly you’re able to screw the pipes to the couplings, as well as the thickness of the boards if you choose a different type of table top.
Good luck making your own Standing Desk!
You’re reading DIY Plumbers Pipe Standing Desk , originally posted on Homedit. If you enjoyed this post, be sure to follow Homedit on Twitter, Facebook and Pinterest.
The post DIY Plumbers Pipe Standing Desk appeared first on Home Decorating Trends – Homedit.
via. Home Decorating Trends